Stops warming up

Hjem Forum Microsafe-produkter Stops warming up

Dette emnet inneholder 0 svar, har 1 deltaker og ble sist oppdatert av  xiaoguang 3 måneder, 1 uke siden.

Viser 1 innlegg (av totalt 1)
  • Forfatter
    Innlegg
  • #210

    xiaoguang
    Participant

    I have Microsafe MTR / MTRNS to control my floor heating in the bathroom. It worked fine at first, after a few months the showed actural temperature was higher than the set temperature (For example, I set at 25, but the T went up to 30). I reset to the factory default parameters, but now it stops warming up the floor at all, even though the red light is still on.

    The Meny parameters are set as following : P0: 20; P1:1; P2:5; P3:1; P4:7; P5:5; P7:5; PA:00

    Is there anything I can do for that?

Viser 1 innlegg (av totalt 1)

Du må være innlogget for å svare på dette emnet.